CRED Fish Biomass Estimates at French Frigate Shoals in the Northwestern Hawaiian Islands, 2002

Metadata also available as - [Outline] - [Parseable text] - [XML]

Frequently anticipated questions:

What does this data set describe?

Title:
CRED Fish Biomass Estimates at French Frigate Shoals in the Northwestern Hawaiian Islands, 2002
Abstract:
Fish biomass data were collected using a Towed Optical Assessment Device (TOAD), an underwater sled equipped with an underwater digital video camera and lights. Data were collected at the Northwestern Hawaiian Islands, French Frigate Shoals to support Benthic Habitat Mapping efforts.
Supplemental_Information:
French Frigate Shoals is a large open atoll located at 23.75N, 166.2W. Tern Island is the largest island at FFS and was enlarged by the U.S. Navy just prior to World War II; numerous other small islets exist. The total land mass is only 0.23 sq. km but the large reef and adjacent banks include 733 sq. km of coral habitat less than 100 m in depth. Mobile fauna data were collected using the Tethered Optical Assessment Device (TOAD), a sled equipped with underwater video camera, still camera, and lights. These data are used to provide fish count and biomass maps where benthic habitat classification has been completed. Camera sled deployments were conducted at night, usually between 1800 and midnight. The TOAD was deployed from a pot hauler mounted on the starboard side of the fantail on NOAA Ship Townsend Cromwell. It was lowered slowly to the bottom by the deck crew with the use of a capstan. The TOAD operator monitored a live video feed from the camera and began recording data on two video tape recorders. When the camera reached bottom the deck crew was notified by radio to stop lowering. The TOAD was a MiniBat 8820 unit manufactured by Guideline, and was towed by the ship at 1-2 knots while remotely guided from the ship using adjustable wing controls to keep the unit close to the underwater substrate. The TOAD was damaged during the cruise on 02/20/02, and subsequent tows were conducted as drift deployments. At each station the ship was positioned with the wind on the starboard side and drifted downwind; occasional light turns were applied to the ship's screws if necessary to reduce the ship's motion. The operator continued to monitor the vehicle and provided commands to raise or lower it to keep the camera just above the bottom. Equipment Description - The TOAD is a camera sled based on the Guildline MiniBat model 8820 tow body. The frame was configured with a single Sony DCR-PC110 Digital Video Camera in a modified Gates underwater housing, a Canon Power Shot G1 Still Camera (modified by CRED engineers) in an Ikelite housing rated to 60 m slaved to an Ikelite DS-50 strobe, and two 500 W DeepSea Power & Light model 710-0400601 underwater lights. The Canon camera had a custom-built timer that enabled the user to select a constant time interval (ranging from approximately 5 seconds to 2 minutes) between photographs. An interval of 30 seconds was typically selected, which, assuming a mean velocity for the camera sled of 1.5 knots, resulted in one photograph approximately every 20 m. Photograph resolution is 2048 x 1536 pixels and file names are assigned sequentially and automatically by the camera, starting at 100-0000 after the camera's memory is cleared. The MiniBat pressure sensor and wing controller were also mounted on the frame but the pressure sensor was not operational. After damage to the TOAD on 02/20/02and the sled's wings were not installed thereafter. The cable between the sled and the surface was an underwater load-bearing electrical cable. The TOAD computers were located in the Electronics Lab of the Townsend Cromwell. The electronics box containing the power switches was secured to the ship's fantail, and all other TOAD surface components were secured in the ship's wet lab. Name & address of person collecting data - Joyce Miller and Ronald Hoeke NOAA PIFSC 1125B Ala Moana Blvd Honolulu, HI 98614 Data Files - Video data were recorded on two video tape recorders. Still photos were recorded on digital camera and downloaded to the TOAD computer after the tow. The position of the camera sled was recorded using Guildline MiniBat In-Tow data acquisition software. File naming convention - Each tow is given a name consisting of a 3-letter designator for the island area, "FFS" in this case followed by a five-digit tow number. The first two digits indicate the last two digits of the calendar year, i.e., "02" is used for this cruise, which took place in 2002. The last three numbers indicate the consecutive number of the tow for that island and year, and start on the next hundred for subsequent cruises in that year to the same island. During TC0207 the consecutive numbers started at 026. Video tape labels, the navigation files (*.glo) and paper log forms are all annotated with the tow name. Metadata were extracted from the navigation data and recorded to a file with the same name as the navigation file except that a file type of ".met" was appended; for example, "FFS02026.glo.met." Time Correlation - All times are based on UTC. Two clocks were set manually synchronized prior to starting data collection; the clock in the video character generator that was used to annotate the video tape and the TOAD data acquisition computer clock was used to annotate the navigation (*.glo) files. These clocks were set to UTC at the beginning of each evening's operations and then compared to one another prior to (and during) each tow. There were problems maintaining synchronization of the TOAD computer clock during this cruise. See the problems section for a description.

Resource Description: Digital video images geo-referenced to navigation files

  1. How should this data set be cited?

    Pacific Islands Benthic Habitat Mapping Center (PIBHMC), Coral Reef Ecosystem Division (CRED), Pacific Islands Fisheries Science Center (PIFSC), National Marine Fisheries Service (NMFS), National Oceanic and Atmospheric Administration (NOAA), 200906, CRED Fish Biomass Estimates at French Frigate Shoals in the Northwestern Hawaiian Islands, 2002.

    Online Links:

  2. What geographic area does the data set cover?

    West_Bounding_Coordinate: -166.34918
    East_Bounding_Coordinate: -166.06448
    North_Bounding_Coordinate: 23.77142
    South_Bounding_Coordinate: 23.63135

  3. What does it look like?

    <http://www.soest.hawaii.edu/pibhmc/NWHI_images/FFS_TOAD_MF_445.jpg> (JPEG)
    French Frigate Shoals, NWHI: TOAD Tows and Multibeam Bathymetry

  4. Does the data set describe conditions during a particular time period?

    Beginning_Date: 13-Sep-2002
    Ending_Date: 13-Sep-2002
    Currentness_Reference: ground condition

  5. What is the general form of this data set?

    Geospatial_Data_Presentation_Form:
    Video and photo imagery, track line navigation files, and log sheets

  6. How does the data set represent geographic features?

    1. How are geographic features stored in the data set?

    2. What coordinate system is used to represent geographic features?

      Horizontal positions are specified in geographic coordinates, that is, latitude and longitude. Latitudes are given to the nearest 0.0001. Longitudes are given to the nearest 0.0001. Latitude and longitude values are specified in Decimal Degrees.

      The horizontal datum used is D_WGS_1984.
      The ellipsoid used is WGS_1984.
      The semi-major axis of the ellipsoid used is 6378137.000000.
      The flattening of the ellipsoid used is 1/298.257224.

      Vertical_Coordinate_System_Definition:
      Depth_System_Definition:
      Depth_Datum_Name: No correction
      Depth_Resolution: 0.1
      Depth_Distance_Units: meters
      Depth_Encoding_Method: Attribute Values

  7. How does the data set describe geographic features?

Who produced the data set?

  1. Who are the originators of the data set? (may include formal authors, digital compilers, and editors)

  2. Who also contributed to the data set?

    Benthic Habitat Mapping Group, Coral Reef Ecosystem Division (CRED), Pacific Islands Fisheries Science Center (PIFSC), National Oceanic and Atmospheric Administration (NOAA)

  3. To whom should users address questions about the data?

    Pacific Islands Benthic Habitat Mapping Center (PIBHMC), Coral Reef Ecosystem Division (CRED), Pacific Islands Fisheries Science Center (PIFSC), National Marine Fisheries Service (NMFS), National Oceanic and Atmospheric Administration (NOAA)
    Attn: John Rooney
    1125B Ala Moana Blvd.
    Honolulu, HI 96814

    (808) 983-3776 (voice)
    (808) 983-2902 (FAX)
    pibhmc@soest.hawaii.edu

    Contact_Instructions: e-mail preferred

Why was the data set created?

These data will provide optical observations that will be correlated with bathymetry and acoustic backscatter imagery to create a fish biomass map of French Frigate Shoals. Refer to supplemental information for description of instrument and survey.

How was the data set created?

  1. From what previous works were the data drawn?

  2. How were the data generated, processed, and modified?

    Date: 18-Mar-2006 (process 1 of 1)
    After a tow was completed the video tape data was reviewed by spot checking the master and backup tape to verify that data were recorded. Navigation data were copied from the acquisition computer to the data archive. A metadata extractor (gloFilter.py, version 3/06) was run to summarize the navigation data and test for errors. If errors were detected they were corrected or flagged as appropriate and a new data file was made. This file's header was updated to document what type of processing occurred. A metadata file was recorded in the data archive in the same location as the navigation data. Processed navigation data were then read into ArcView 3.2 shapefiles using an ArcView Avenue script named "TOAD.Import.Playback", version 9/25/01, written by Ronald Hoeke. TOAD video were classified for benthic habitat type to create Optical Validation maps to interpret acoustically derived data layers. These classified points were imported into a Microsoft Access 2003 database. All fish present during 15 second intervals before and after these positions were recorded and identified. Using LW coefficients derived from fishbase.org and size estimates from video, total biomass was calculated for a given point. An area of 0.0012 hectares per point observation was assumed based on average distances traveled between points as well as average width of field of view. A table with position, island, biomass(tonnes/hectare), and number of fish was exported from MS Access into ArcGis v9.3. This file was exported as a shapefile. A column with biomass data was symbolized using layer file MF_Biomass.lyr to create Fish Biomass Estimates map.

  3. What similar or related data should the user be aware of?

How reliable are the data; what problems remain in the data set?

  1. How well have the observations been checked?

  2. How accurate are the geographic locations?

    The horizontal position accuracy for the camera sled position is 100 meters. There are three primary sources of this error. The ship's positioning is based on GPS SPS, often called standalone or non-differential GPS positioning. SPS has a measured accuracy of under 5 meters. The position of the GPS antenna is used; no attempt is made to translocate this position to that of the tow block from which the camera is deployed. The difference between the tow block and the antenna is about 14 meters. The camera sled position is based a layback calculation that use ship's course, the amount of cable out and the camera sled depth to develop an estimate of the camera sled position. The amount of cable deployed is manually entered by the operator during a given camera tow.

  3. How accurate are the heights or depths?

  4. Where are the gaps in the data? What is missing?

    Complete

  5. How consistent are the relationships among the observations, including topology?

    Unspecified

How can someone get a copy of the data set?

Are there legal restrictions on access or use of the data?

Access_Constraints: None
Use_Constraints:
Please acknowledge the NOAA Coral Reef Ecosystem Division, Pacific Islands Fisheries Science Center as the source of this information.

  1. Who distributes the data set? (Distributor 1 of 1)

    Pacific Islands Benthic Habitat Mapping Center (PIBHMC), Coral Reef Ecosystem Division (CRED), Pacific Islands Fisheries Science Center (PIFSC), National Marine Fisheries Service (NMFS), National Oceanic and Atmospheric Administration (NOAA)
    Attn: John Rooney
    1125B Ala Moana Blvd.
    Honolulu, HI 96814

    (808) 983-3776 (voice)
    (808) 983-2902 (FAX)
    pibhmc@soest.hawaii.edu

    Contact_Instructions: e-mail preferred
  2. What's the catalog number I need to order this data set?

    Downloadable Data

  3. What legal disclaimers am I supposed to read?

    These data are not to be used for navigational purposes. NOAA makes no warranty regarding these data, expressed or implied, nor does the fact of distribution constitute such a warranty. NOAA cannot assume liability for any damages caused by any errors or omissions in these data, nor as a result of the failure of these data to function on a particular system.

  4. How can I download or order the data?

Who wrote the metadata?

Dates:
Last modified: 17-Dec-2012
Last Reviewed: 31-Aug-2010
Metadata author:
Pacific Islands Benthic Habitat Mapping Center (PIBHMC), Coral Reef Ecosystem Division (CRED), Pacific Islands Fisheries Science Center (PIFSC), National Marine Fisheries Service (NMFS), National Oceanic and Atmospheric Administration (NOAA)
Attn: CRED Data Management Team
1125B Ala Moana Blvd.
Honolulu, HI 96814

(808) 983-3776 (voice)
(808) 983-2902 (FAX)
pibhmc@soest.hawaii.edu

Contact_Instructions: e-mail preferred
Metadata standard:
FGDC Content Standards for Digital Geospatial Metadata (FGDC-STD-001-1998)

Generated by mp version 2.9.13 on Fri May 24 06:53:23 2013